281
11. Using the Wi-Fi function
1 Select the menu. (P53)
2 Select [Via Network], and connect. (P288)
3 Check the send settings, and select [Set].
•
To change the send setting, press [DISP.]. (P295)
4 Take pictures.
•
To change the setting or disconnect, press [Wi-Fi]. (P250)
You cannot change the settings while sending pictures. Wait until sending is complete.
(You can also terminate the connection by performing the following operations:
>
[Setup]
>
[Wi-Fi]
>
[Wi-Fi Function]
>
[Yes]
)
1 Select the menu. (P53)
2 Select [Via Network], and connect. (P288)
3 Check the send settings, and select [Set].
•
To change the send setting, press [DISP.]. (P295)
4 Select [Single Select] or [Multi Select].
Sending an image each time a recording is made ([Send Images While
Recording])
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [New Connection] >
[Send Images While Recording] > [Cloud Sync. Service]
Select and send the images ([Send Images Stored in the Camera])
> [Setup] > [Wi-Fi] > [Wi-Fi Function] > [New Connection] >
[Send Images Stored in the Camera] > [Cloud Sync. Service]
[Single Select] setting
1 Select the picture.
2 Select [Set].
[Multi Select] setting
1 Select the picture. (repeat)
•
The setting is cancelled when the picture is selected
again.
2 Select [OK].
•
The number of pictures that can be sent by [Multi Select]
is limited.
• Confirmation screen is displayed. It is executed when [Yes] is selected.
• To change the send settings on a screen that is displayed after the image has been sent,
press [DISP.]. To terminate the connection, select [Exit].
MENU
MENU
6HW
2.
To Next Page
Loading...
