Preparation
25
Setting the Date/Time (Clock Set)
If the message [PLEASE SET THE CLOCK]
appears, set the date and time.
You can go to the setup menu by pressing the
[MENU] button while the message is
displayed.
You can set the year from 2003 to 2099. The
24-hour system is used.
1 Press the [MENU] button.
2 Press 1 to make the setup menu
appear.
• In simple mode, skip this step.
3 Press 3/4 to select [CLOCK SET],
and then press 1.
4 Press 3/4/2/1 to set date and time,
and then press 1.
5 Press 3/4 to select [M/D/Y], [D/M/Y] or
[Y/M/D].
6 Press the [
MENU
]
button 2 times.
• The menu will disappear.
7 Check if the date/time setting is
displayed correctly, after turning the
camera [OFF] and [ON].
• When the new batteries are inserted in the
camera for more than 3 hours, the time and
date will be held for approximately 3 months
if the battery is removed. If the batteries
were not new, the time may not be retained
properly. If the time/date setting is lost
please reset it.
1,6
2,3,4,5
7
4,5
CLOCK SET
SELECT SET EXIT
MENU
2003
NOV
1:..0010
M/D/Y
NO.RESET
CLOCK SET
3
SELECT SET EXIT
MENU
SETUP
2/3
REC
RESET
BEEP
KC93-PP.book 25 ページ ２００３年３月１９日 水曜日 午後２時１１分
To Next Page
Loading...
