- 87 -
Burst function
Recording mode:
A burst of still pictures can be recorded while the shutter button is pressed fully.
Select [Burst] from the [Rec] menu (→51)
Use cursor button to select the burst setting, and press
[MENU/SET]
Setting Speed Description
No. of
pictures
∗
1
Approx. 2 - 10
pictures/sec.
• The burst speed is adjusted automatically in
accordance with the movements of people, pets
or other subjects. ([Intelligent Burst mode])
• When a fast-moving subject is recorded, the
frame rate becomes faster and the number
of pictures that can be recorded in a series is
restricted to about 10.
100
∗
2
Approx. 2
pictures/sec.
• The subject is brought into focus as far as this
is allowed by the burst speed. The pictures are
taken with the burst function while the exposure
and White Balance are being adjusted.
(However, when the burst function is operating
during motion picture recording, the focus is
fixed to the first picture.)
• The burst speed may be reduced under certain
recording conditions.
100
∗
2
Approx. 5
pictures/sec.
Approx. 10
pictures/sec.
• Focus, exposure and White Balance are fixed in
the first picture.
10
40 pictures/sec.
• Focus, exposure and White Balance are fixed in
the first picture.
• Note on the picture size setting (→88)
40
60 pictures/sec.
• Focus, exposure and White Balance are fixed in
the first picture.
• The recordable range is reduced.
• Note on the picture size setting (→88)
60
∗
3
Complies with
recording
conditions
• The burst of still pictures can be recorded even
in low light conditions as the flash is used.
([Flash Burst])
• The focus, exposure, and flash level are all
fixed to the settings for the first picture.
• Note on the picture size setting (→88)
5
[OFF] — The burst function is released. —
∗
1
Only in the mode
∗
2
The number of burst pictures is limited by the picture-taking conditions and the type and/or
status of the card used.
∗
3
Only in the , , mode
To Next Page
Loading...
Need help?
General
Weight and Dimensions
