26 VQT1Z82 VQT1Z82 27
See P.18 for the setting procedure in the SETUP menu.
Using SETUP menu
(Continued)
VIERA Link
Enable automatic linking
with other VIERA Link-
compatible devices,
and operability with a
VIERA remote control
when connecting via an
HDMI mini cable (sold
separately) (P.109).
OFF: Operations must be performed via the camera’s own
buttons.
ON: Operations may be performed via the remote control
of the VIERA Link-compatible device.
(Not all operations will be available.) Operability of
the camera’s own buttons will be limited.
• Works when connected via an HDMI mini cable
(sold separately).
VERSION DISP.
Check the version of the
camera firmware.
Current version is
displayed.
FORMAT
Use when ‘BUILT-IN
MEMORY ERROR’
or ‘MEMORY CARD
ERROR’ appears, or
when formatting the built-
in memory or card.
When a card/built-in
memory is formatted,
the data cannot be
restored. Check the
content of the card/
built-in memory
carefully before
formatting.
YES/NO
• This requires a sufficiently charged battery (P.13) or AC
adaptor (DMW-AC5PP, sold separately).
(Only inserted card will be formatted if present; built-in
memory will be formatted if no card is inserted.)
• Always format cards with this camera.
• All picture data including protected pictures will be
deleted. (P.97)
• Do not turn off power or perform other operations during
formatting.
• Consult your nearest Service Center if format cannot be
successfully completed.
• Formatting the built-in memory may take several minutes.
LANGUAGE
Change display
language.
ENGLISH
/ DEUTSCH (German) / FRANÇAIS (French) /
ESPAÑOL (Spanish) / ITALIANO (Italian) / 中文 (Chinese) /
日本語 (Japanese)
Not displayed on DMC-ZS3P/DMC-ZS1P.
Item Settings, notes
The ‘VIERA Link’ menu item is not available in the DMC-ZS1.
Item Settings, notes
DEMO MODE
View demonstration of
functions.
JITTER, SUBJ. MOVE DEMO.: (Only during recording)
Extent of jitter and of subject movement are shown on
graph. (Estimate)
Movement detection
Jitter
Large ← Small → Large
• When the REC/PLAY switch is , a guidance message
is displayed that asks the user to switch to .
• To stop→ Press display button (P.12).
• Recording and zoom cannot be performed during demo.
• Use the movement detection demo with objects with
contrasting coloring.
AUTO DEMO: View introductory slideshow
OFF/ON
• To close → Press ‘MENU/SET’
• If the camera is left switched on while connected to the
AC adapter (DMW-AC5PP, sold separately) and with no
card inserted, the demo will automatically begin whenever
no operations are performed for approx. 2 minutes.
To Next Page
Loading...
Need help?
General
