- 129 -
Message displays
[Memory card parameter error]
●
Card is not of SD standard.
●
When cards in capacities of 4 GB or more are used, only SDHC or SDXC Memory Cards are
supported.
[Read Error] / [Write Error] [Please check the card]
●
Data read has failed.
→ Check whether card has been inserted correctly (→15).
●
Data write has failed.
→ Turn off power and remove card, before re-inserting and turning on power again.
●
Card may possibly be damaged.
●
Try with a different card.
[Cannot record due to incompatible format(NTSC/PAL) data on this card.]
●
Format the card after saving necessary data on a PC etc. (→48)
●
Insert a different card.
[Motion recording was cancelled due to the limitation of the writing speed of the card]
●
If recording stops even when using a card of the recommended speed class (→16), the data writing
speed has dropped. If this happens, we recommend backing up the data on the memory card and
formatting it (→48).
●
Motion picture recording may be automatically terminated with certain cards.
[A folder cannot be created]
●
Folder numbers in use have reached 999.
→ Save needed data on a computer or other device, and then use [Format] on the camera. (→48)
Folder number is reset to 100 when performing [No.Reset] (→46).
[Picture is displayed for 16:9 TV] [Picture is displayed for 4:3 TV]
●
AV cable (optional) is connected to camera.
→ To remove message immediately → Press [MENU/SET].
→ To change aspect ratio → Change [TV Aspect] (→47).
●
USB connection cable (supplied) is only connected to camera.
→ Message disappears when cable is also connected to another device.
[This battery cannot be used]
●
Use a genuine Panasonic battery.
●
Battery cannot be recognized as terminal is dirty.
→ Wipe any dirt away from the battery terminal.
[Recording failed.]
●
Recording may be impossible if the recording location for a 3D image is too dark/too bright, or if the
subject lacks contrast.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
