6
4.3. Disassembly of Cord Reel Unit
Step 1 Release the pretension of the Cord Reel Unit slowly by
holding on the Power Plug and pressing on the Brake Lever.
Step 2 Remove the Cord Reel Unit from the Motor Case Set by
inserting a slotted screwdriver into the shaft of the Cord Reel
Unit and turning it 90° counter-clockwise.
To assemble:
Step 1 Assemble in reverse order of the disassembly.
Step 2 Pretension the Cord Reel Unit.
-Turn the Cord Reel Unit holding on the plug
-Number of turns for pretension of the Cord is engraved on the
steel at the side of Cord Reel Unit.
4.4. Disassembly of Rail Base Unit
Step 1 Remove 1 screw.
Step 2 Release the Catch and pull upward.
Step 3 Remove the Faston Terminals on the Rail Base Unit.
To Next Page
Loading...
