31
MENU
ENTER
VARIOUS SETTING (MENU/Tools)
Change of compressor delay time (Tools/Comp. Delay)
There is a starting delay time setup (Comp Delay) of A compressor /B compressor in the power failure
recovery in this product. Setting can be set from 3 to15 minutes. A compressor setup in the factory
shipment is 3 minutes. An A compressor starts first. (it is seen from the rear, the left)
A compressor starts B compressor, and starts after about one minute.
Table 13 Compressor starting delay time setup process (When the starting delay time of the
compressor is changed from 3 minutes to 5 minutes.)
Description of operation Key operated Indication after operation
1 -----
Top screen is displayed
2 Press the MENU button. MENU
The menu window is indicated. And the
“set” is highlighted.
3
Press the shift key, highlight the
“Tools” menu window, and press the
ENTER key.
Select Tools window is indicated.
4
Press the shift key, highlight the
Date Time by pressing ENTER keys.
The Date is highlighted
5
Select Comp Delay by pressing
MENU button. Then, pressing
ENTER key
Comp Delay setting window is indicated.
6
Figure input key is pressed in order
of 0, 5.
Comp Delay is changed at 3 to 5.
7
Press the ENTER key.
ENTER
The menu window is indicated. And the
“OK” is highlighted.
8
Press the MENU button.
MENU
Comp Delay time is memorized, and the
Select tools window is indicated.
9
The shift key is pressed, and made
to highlight Cancel of the menu
window, and press the ENTER
key.
ENTER
Top screen is displayed
ENTER
0
5
To Next Page
Loading...
