4) Remove 2 washers and take Tension Plate.
Fig. D20-
1
1) Remove a screw and take T4 Guide out.
Fig. D20-
2
2) Remove a washer and take Eject Lever out.
*20 T4 Guide , Eject Lever , Pulley Cover &
Pulley.
Fig. D20-
3
3) Remove 2 screw and take Pulley Cover out.
4) Take Pulley out.
*21 S3 Base U. Fig. D21 1) Remove a screw for S3 adjustment and take S3 Base U.
* 1) Procedure 2 for H.Amp Unit is applied only Q1 & Q2
mechanism.
2) Procedure 19 - 21 can be changed in order.
Fig. D1-1
Fig. D1-2
To Next Page
Loading...
