EN12
After Use
Storing
Note:
• Do not wrap the Cord around the Motor Housing.
• Mount the Blender Jug onto the Blender Jug Base and store it.
• Mount the Mill Container onto the Mill Container Base and store it.
Cleaning
Note:
• During prewash, do not fi ll in the normal water more than the amount indicated. It may cause high vibration.
• After prewash, unplug the appliance before cleaning. Handle the Cutting Blades and glass parts carefully during
cleaning.
• Do not use benzene, thinner, alcohol, bleach, polishing powder or metal brush to clean the appliance. The surface
may be damaged.
• Do not place the appliance in the dishwasher or the dish dryer for cleaning.
• Some discolouration of the plastic parts may occur upon usage but it does not affect usage.
• Make sure to clean the appliance after every use.
• Do not use water or hand to clean the Mill Cutting Blade.
Cleaning with a brush
• Wipe the Motor Housing with a damp cloth.
• Clean the Mill Container Base and the Mill Cutting Blade with a brush.
Do not use water or hand to clean the Cutting Blades.
* Brush is not provided.
Prewash
• For Blender, fi ll in 750 mL of normal water. Press
P2
while holding the
Blender Jug by hand and operate for 3 to 10 times for cleaning.
1500
1000
500
Wash
• Before cleaning, make sure to take out the Blender Gasket
and the Mill Gasket.
• Wash with diluted dish soap (neutral) and a soft sponge. After
washing, be sure to rinse and wipe dry thoroughly.
Wiping
1500
1000
500
Blender_MX-KM5080.indb 12Blender_MX-KM5080.indb 12 5/20/2020 3:47:16 PM5/20/2020 3:47:16 PM
To Next Page
Loading...
