EN4
CAUTION
To prevent electric shock, fi re caused by a short circuit, burning, injury
or smoke.
● Do not replace any parts of the appliance with non-genuine spare parts.
● Do not leave the appliance unattended when it is in operation.
• When leaving the appliance unattended, turn the power Off.
● Do not use the appliance on following places:
• Any uneven surface, on non-heat resistant carpet, table cloth, etc.
• The place where it may be splashed with water or near a heat source.
● Do not blend more than 1.5 L working capacity marked on the Blender Jug.
● Do not place more than the maximum working capacity allowed for the Mill
Container. Follow the recommended ingredient amount for processing.
● Do not operate without the Blender Lid and the Inner Lid in place correctly
for the Blender Jug.
● Always disconnect the appliance from the supply if it is left unattended and
before assembling, disassembling or cleaning.
● Make sure to hold the Plug when unplugging. Never pull on the Cord.
● Ensure to operate and rest the appliance based on the table below:
Function
Operating Time
(min)
Rest Time
(min)
Blender 2 2
Dry Mill 1 2
● Unplug the appliance when not in use.
● When carrying the appliance, be sure to hold the Motor Housing with both
hands.
● Switch off the appliance and disconnect from the power supply before
changing accessories or approaching parts that move in use.
● Care shall be taken when handling the sharp Cutting Blades, emptying the
Blender Jug or the Mill Container and during cleaning.
● Operate the appliance on a clean, fl at, hard and dry surface.
● If the Blender Cutting Blade gets stuck, switch off immediately and unplug.
Do not insert fi nger into the Blender Jug. Use the Scraper to remove the
ingredients that are blocking the Blender Cutting Blade.
● This product is intended for household use only.
● Ensure to clean the surfaces in contact with food after use. (See Page EN12
"After Use".)
Blender_MX-KM5080.indb 4Blender_MX-KM5080.indb 4 5/20/2020 3:47:13 PM5/20/2020 3:47:13 PM
To Next Page
Loading...
