Troubleshooting - 27
Fault Checklist
Problem Cause
Washing machine
Buttons do not work. The programme, temperature, preset time, or Extra Rinse -
function settings cannot be changed while washing is in
progress.
Child lock may be activated. (See page 22.) -
Door does not open. Door lock may be activated. (See page 13.) -
The water temperature or level may be too high. (See -
page 13.)
Unusual odour Rubber parts may give off a smell when you start using -
the appliance, but the smell will go away over time.
You can wash the drum by running the 90°C programme.
(See page 24.)
Wash
No water going into
the appliance.
The water tap might be turned off. -
The water-supply hose may be frozen. (See page 26.) -
The water supply may be disrupted. -
The water-supply filter may be clogged. (See page 26.) -
There is only a small
amount of water.
If you have paused the washing and then restart it, the -
appliance may drain out some water.
Do NOT pour water in through the door.
Water builds up
during the washing.
This is normal; water is automatically supplied if the -
amount of water has decreased. For heavy loads, the
water may fill up repeatedly.
Rinse/Spin
No water flows into
the appliance during
the rinsing process.
Before rinsing, the appliance spins to drain out remaining -
water. The water will fill up after that.
Rinsing begins
before the spin
process finishes.
After washing, excess foam may remain, so the water is -
drained out and refilled to wash it away. This feature is
called foam detection.
During spin-dry,
the drum stops and
rotates several times.
This is normal; the appliance has detected an unbalanced -
load and is trying to correct it.
Foam and water
remain in the door or
door seal.
Although some foam and water might remain depending -
upon the state of the laundry and the amount of detergent
used, the performance of the rinse cycle is unaffected.
Spin cycle repeatedly
starts and stops.
This is normal; intermittent spinning of the tub helps the -
spin process to operate quietly.
The laundry may be too light. If so, add one or two bath -
towels.
The laundry is still
wet after the spinning
finishes.
An unbalanced load is not corrected automatically. -
If the laundry is too light, add one or two bath towels. -
If the laundry gets tangled up, untangle it. -
To Next Page
Loading...
