Why is no water going into my Panasonic NA-147VR1 Washer?
If your Panasonic Washer isn't getting any water, it could be due to several reasons: * The water tap may be turned off. Turn on the water tap. * The water supply hose may be frozen. Check the water supply hose. * The water supply may be disrupted. Investigate the water supply disruption. * The water supply filter may be clogged. Clean the water supply filter.
Why is my laundry still wet after the spin process finishes in my Panasonic NA-147VR1 Washer?
If your laundry is still wet after the spin process finishes in your Panasonic Washer, it could be due to a few reasons: * The unit detected an out of balance load but was not able to correct it automatically; check the load balance. * If the laundry is too light, add one or two bath towels. * If the laundry gets tangled up, untangle it.
Why does the spin process repeatedly start and stop in my Panasonic NA-147VR1 Washer?
If the spin process in your Panasonic Washer repeatedly starts and stops, this is normal; intermittent spinning of the tub helps the spin process to operate quietly. If the laundry may be too light, add one or two bath towels.
Why does my Panasonic NA-147VR1 Washer drum stop and rotate during spin-dry?
If the drum in your Panasonic Washer stops and rotates several times during spin-dry, this is normal; the appliance has detected that the load is not balanced and is trying to re-distribute the clothes within the drum to correct it.
Why does water build up during the wash process in my Panasonic NA-147VR1 Washer?
If water builds up during the wash process in your Panasonic Washer, this is normal; water is automatically supplied if the amount of water has decreased. For heavy loads, the water may fill up repeatedly.
Why is there only a small amount of water in my Panasonic Washer?
If there is only a small amount of water in your Panasonic Washer, if you have paused the washing and then restart it, the appliance may drain out some water. Do NOT pour water in through the door.
Why is there foam and water remaining in the door or door seal of my Panasonic NA-147VR1?
If foam and water remain in the door or door seal of your Panasonic Washer, although some foam and water may remain depending upon the state of the laundry and the amount of detergent used, rinse performance is unaffected.
Why does no water flow into my Panasonic Washer during the rinse process?
If no water flows into your Panasonic Washer during the rinse process, it's because before rinsing, the appliance spins to drain out remaining water. The water will fill up after that.
Why do my Panasonic NA-147VR1 buttons not work?
If the buttons on your Panasonic Washer aren't working, it might be because the child lock is activated. Deactivate the child lock. Also, the programme, temperature, spin speed, preset time, Rinse+, Easy Iron, Prewash or Dirt Level function settings cannot be changed while washing is in progress.
Why does rinsing begin before the spin process finishes in my Panasonic NA-147VR1?
If rinsing begins before the spin process finishes in your Panasonic Washer, it’s because after washing, excess foam may remain, so the water is drained out and refilled to wash it away. This feature is called foam detection.
General| Capacity | 7 kg |
|---|---|
| Spin Speed | 1400 RPM |
| Energy Rating | A+++ |
| Weight | 70 kg |
| Color | White |
| Water Level Selection | Automatic |
| Voltage | 220-240 V |
| Frequency | 50 Hz |
| Loading type | Front |
To Next Page