Operation Panel
9
NOTE
In case of a power failure
during operation, operation will
resume from the point where it
was stopped when the power is
recovered (Auto Restart).
The power turns off
automatically if you do not
press “Start/Pause” within
10 minutes after power-on.
Water level/water amounts
Level
High
10-8
Mid
7-5
Low
4-2
Extra Low
1
Model
Detergent*
NA-F150A5
NA-F130A5
Water
amount (L)
96 88 81 73 66 58 52 46 38 33
* : 1 scoop of detergent
Each water level, except “Extra Low”, has three water amount options that
can be switched while the level is lighted by pressing “W
ater Level”.
Temp Setting
For washing, cold water can be mixed
with hot water. Press the button to select
Hot/Warm/Cold. (P. 14)
Do not use water hotter than 60 ºC.
The estimated water temperature in
the tub during wash process (when hot
water is 50 ºC, and normal water is
20 ºC):
Hot approx. 40 ºC
Warm approx. 30 ºC
Lamp indications
Lighted: Hot/W
arm/Cold is set.
Flashing: Hot water is being supplied.
Not available for the following
programs:
Gentle Hand Wash, Tub Hygiene, Super Dry
Program selection (P. 10)
Power Off/On
Stain Master (P. 17)
To Next Page
Loading...
