7
3. INSTALLATION
3.2 Connect the water supply hose
[Note]
- Firmly tighten part B of the water tap adaptor,
otherwise water leakage will result.
- When the hose must be reinstalled (after you
remove, for example), turn B to the left until
about 4 mm of the thread becomes visible,
then carry out the procedure described above.
- If a water tap adaptor is already connected,
replace with the attached new one.
3.3 Install Washing Machine to steady
1. Turn the adjustable leg knob towards (Loosen)
direction to loose it.
2. Turn the adjustable leg to adjust the levelness.
2.1 When increasing height, turn adjustable leg
towards (Loosen) direction.
2.2 When decreasing height, turn adjustable leg
towards (Tighten) direction.
3. Turn the adjustable leg knob towards (Tighten)
direction to tighten it.
If the floor is largely inclined
3.4 CHILD LOCK Program
Press the [ POWER OFF/ON] button for at least 5
seconds. The buzzer sounds (two time for setting)
and the [CHILD LOCK] indication turns on.
Open lid
Close lidBuzzer on Buzzer off
Water drain
Buzzer on and
abnormal alarm
Unplug the power
cord from the
outlet and re-plug
it again after
5 seconds
Adjust Height of leg
Less than
10 sec.
More than
10 sec.
Water faucet
Water supply
hose cover
A
B
Screw (4)
Water tap
adaptor
Lever
Approx. 4 mm
B
Adjustable leg knob
Adjustable leg
Loosen
To raise
To lower
Tighten
Use board or
a like for prop
up under leg
of washing
machine
To Next Page
Loading...
