To Next PageTo Next PageHow to prevent softener spills in Panasonic NA-F80T1 Washer drawer?
If softener spills from the drawer of your Panasonic Washer, ensure you keep the softener level below the indicated line to prevent immediate overflow. Also, avoid closing the drawer forcefully.
Why my Panasonic Washer does not run?
If your Panasonic Washer doesn't run, try these steps: * Check for a power failure. * See if the power fuse has blown or the breaker is activated. * Make sure the power plug is fully plugged in. * Ensure the 'power switch' is pressed. * Verify the water faucet is turned on. * Confirm the [START/HOLD] button has been pressed. * Check if the machine is programmed under the [RESERVE] timer.
How to fix Panasonic NA-F80T1 Washer when water is not supplied?
If water is not being supplied to your Panasonic Washer, start by checking if the water faucet is turned on and if the water supply has been cut off. Also, inspect the water supply hose connection for any clogs with dirt. Ensure that the lid is closed properly.
Why is my Panasonic NA-F80T1 tub not filling with water when I start the rinse cycle?
If, when starting with the rinse cycle on your Panasonic Washer, the tub doesn't fill with water, the machine will first drain any existing water in the tub. After the spin cycle finishes, the tub will then fill with water.
Why is the water level too high in my Panasonic Washer?
If the water level in your Panasonic Washer seems too high for the amount of laundry, it could be because the laundry was already soaked before starting the wash, or there was water in the tub beforehand.
What to do if Panasonic NA-F80T1 has water supply failure?
If you experience water supply failure with your Panasonic Washer, the water may become muddy. Detach the water feeding hose, turn on the faucet to release the muddy water, then reattach the hose and start washing.
Why does water drain from my Panasonic Washer even when filled manually?
If water drains from your Panasonic Washer even when filled by a bucket, avoid leaving the machine powered on for more than 15 seconds without starting a cycle. Fill water while the machine is powered off or after pressing the start button.
Why is my Panasonic NA-F80T1 tub shaking with a water sound?
This sound from your Panasonic Washer is the liquid to maintain balance during spinning.
Why does my Panasonic Washer start filling with water in the middle of the wash?
If your Panasonic Washer is filling with water mid-cycle, especially at the HIGH water level with a large laundry load, this is normal. The machine fills automatically when the water level goes down.
Why does my Panasonic NA-F80T1 Washer buzzer sound when I open the lid during rinsing or spinning?
If you open the lid of your Panasonic Washer during cascade rinsing or spinning and hear a buzzer, this is a reminder not to put your hand or any object into the tub. It is not a malfunction. To turn off the buzzer, simply close the lid.
General| Capacity | 8.0 kg |
|---|---|
| Wash Programs | 10 |
| Water Level Selection | 5 Levels |
| Voltage | 220 V |
| Frequency | 50 Hz |
| Type | Top Load |
| Features | Aqua Spin Rinse |
Steps to ensure the washing machine is correctly installed before operation.
Explanation of the indicator for optimal detergent amount.
Table detailing detergent amounts based on water level and type.
Instructions for using liquid detergent in the designated inlet.
Guidance on using liquid and powder bleach, including special courses.
Instructions for correctly adding softener for optimal results.
Guidance on dissolving powdered detergent for effective washing.
Method for reusing wash water for multiple loads to save resources.
Explanation of the water level indicator and adjustment.
Information on how the remaining time is shown during operation.
Details on operating the power button and program selection controls.
Explanation of the reserve timer and soak program options.
Detailed steps for folding and preparing blankets for washing.
Instructions for cleaning lint filters and the water supply hose filter.
Guidance on cleaning the washing machine's main body and inner tub.
Warnings regarding the power cord and potential damage to parts.
Guidelines for selecting location, grounding, and power cord connection.
Steps to ensure the machine is level using adjustable legs.
Steps to relocate the drain hose from right to left side.
