Why my Panasonic Washer does not run at all?
If your Panasonic Washer isn't running, first ensure the power plug is fully inserted. Then, check your power fuse and breaker. Also, make sure the water faucet is turned on and that you've pressed the START/HOLD button. Finally, verify that the machine hasn't been programmed under the RESERVE timer.
How to fix Panasonic Washer when water is not supplied?
If water is not being supplied to your Panasonic Washer, start by checking if the water faucet is turned on and if the water supply has been cut off. Also, inspect the water supply hose connection for any clogs with dirt. Ensure that the lid is closed properly.
What to do if buzzer sounds and draining when opening the lid during wash and rinse on Panasonic NA-F90H1?
If your Panasonic Washer buzzer sounds and drains when you open the lid during wash and rinse, it's likely due to the CHILD LOCK mode being activated. To resolve this, unplug the power cord from the outlet, wait 5 seconds, and then plug it back in.
Important safety information for experienced repair technicians.
Highlights critical safety components and manufacturer's specified parts.
Details model variations, voltage, frequency, color, and destination.
Explains buttons like RESERVE, WATER LEVEL, RINSE, WASH/SPIN, PROGRAM, START/HOLD.
Details operations for NA-F80H1/NA-F90H1 including Ag Shower.
Schematic for electronic controller, feed valve, motor, and sensors.
Schematic for electronic controller, feed valve, motor, and sensors for specific models.
Lists error codes (U11, U12, U13, U14, U99, H01) and their meanings.
Cross-references problems with corresponding devices and potential causes.
General| Type | Top Load |
|---|---|
| Capacity | 9 kg |
| Voltage | 220-240 V |
| Frequency | 50 Hz |
| Wash Programs | 8 |
| Water Level Selection | Yes |
| Foam Sensor | Yes |
| Child Lock | Yes |
| Water Level | 5 Levels |
To Next Page