Panasonic NA-FS14G2 - Page 8

Check Contents
• Press the "WASH" button to adjust L0 (initial
mode) to L1 (1-rank higher water level).
• Press "STAR/PAUSE" button to confirm.
• In case to change PCB or remove the V-belt.
set the V-belt tension to initail mode for useing
below procedure.
M • The initial display will be indicated "b0"
after that, press "START / PAUSE" button once,
it shall be listened click sound six times to
set properly.
• "Digit lights" shall be indicated "E" initially,
Press "WASH" button to show the last error,
and press the wash botton again to return
to initial mode.
G • If any error message occurred in the
past, "H" or "U" and some number shall
be indicated alternately.
If no error message occurred, the light
indicates "00".
‧"Digit lights" shall be indicated "C" initially,
Press "WASH" button to change "Indication
H of dight" of operation times.
Press once: Digit "Thousand‧Hundred"
Press twice: Digit "Ten‧One"
Operation condition
Check
Procedure
Lamp illumination condition
•Set to initial
mode for
tension of the
Belt
Number of times
the "Water lever"
button is pressed
3
E
4
• Indicate the
error message
of the last time.
• Indicate the
operation
times.
• Adjust the
water amount
against laundry
amount
detection
5
6
-7-