Panasonic NC-TSC500 - Brewing Coffee; Filter and Basket Setup; Adjusting Coffee Taste

EN14
Care & Clearing
●
Unplug and be sure that appliance and part have cooled down before cleaning.
●
Do not use dishwasher, dish-dryer or hot water. (It may cause cracking or malfunction.)
●
Clean the appliance after every use.
A
C
D
B
Wipe with a damp cloth and
dry well.
Inside of the lid
●
Wipe splattered
coffee powder.
Main unit, bean hopper, bean hopper lid
Clean the water tank with citric acid when brewing speed is slow
While using this appliance, the mineral contained in the water adheres to the water tank or
the water pipe. This is called “scale” and if it adheres, hot water goes through uneasily and
it causes the brewing speed gets slow.
●
Using the water contains more minerals (especially hard type mineral water from Europe)
made more build-up scale.
●
Make sure only use pure citric acid for washing.
For purchasing our citric acid, contact us using the contact list in the warranty.
(Part No: SAN-80N)
Notice
●
If cleaning cycle is completed with the charcoal filter, take it off and rinse well with cold tap
water to remove the small of citric acid.
Warming plate
Wipe with a damp cloth after every
use.
Wash with a soft sponge
and dry it well after every use.
●
Take off the mesh filter.
(P. EN13)
( After that, discard the
remaining coffee beans
or/and coffee powder from
the bean hopper.)
Discard the coffee powder by turning the blade
with the stick. (Do not use fingers.)
Mesh filter
NC-TSC500.indb14NC-TSC500.indb14 2016/08/0913:54:592016/08/0913:54:59
EN15
English
Wash with a soft sponge.
A
Charcoal filter
Remove and rinse
well with cold tap
water. (P. EN6)
●
Do not use brush, detergent,
breach, etc.
( It may damage, leave
an odor or reduce its
purification effect.)
C
Glass jug lid
●
Do not use bleach or soap,
etc.
( Decrease the effect of
mineral filter.)
D
Glass jug
●
Can be washed in warm soapy water and rinsed
thoroughly. Dry it after every use. (Only use natural
dish soap.)
●
Do not use polishing powder, brush or nylon
sponge. (If the surface is damaged, it may cause
fracture.)
B
Basket (Anti-drip valve)
After removing the parts,
rinse it with tap water. (P. EN7)
#
Pour water in the basket.
$
Push the anti-drip valve
up and shake it for 2 to 3 times.
●
Stops flow of coffee from basket when glass jug is
removed from warming plate. (If the valve is clogged,
it may cause coffee leakage.)
●
Handle with care not to
come out O-ring (a small
ring part) while washing.
#
$
( Look down “O-ring”
from above.)
Water tank, charcoal filter, basket, basket lid, glass jug, glass jug lid

■
How to clean with citric acid
#
Take off the charcoal filter surely. (P. EN6)
$
Fill the water tank with cold water up to 5 on the scale of
HOT coffee “
” and add approximately 10
g
(1 tablespoon)
of citric acid.
Then mix well with a stick and close the lid.
%
Plug in and press .
&
Press to power off and drain away the hot water.
(
Repeat step
$
to
&
with only water to remove the small of
the citric acid.
O-ring
NC-TSC500.indb15NC-TSC500.indb15 2016/08/0913:54:592016/08/0913:54:59
100121875_NC-TSC500_tori
Refine_16-08-09 14:44:30
Refine_0015_NC-TSC500.p1.pdf
Refine_16-08-09 14:44:30
Refine_0014_NC-TSC500.p1.pdf
8 16-08-09 15:30:28