Panasonic NE-1027 - Reheating, Standing Time, and Cleaning

2.1. Manual Heating for Single
Stage
OPERATION DISPLAY
1. Plug the power supply cord into
wall receptacle.
2. Open the door.
Place a water load in the oven
and close the door.
3. Press Power Level pad
once.
(Sets to HIGH power)
4. Press 2 ,0,0 pads.
(Sets to 2 minutes)
5. Press Start pad.
(Sets to 2 minutes)
6. When cooking time has
elapsed, oven beeps 5 times
and shuts off. Display blinks
zero.
7. Open the door and take out the
water load. Display stops
blinking.
8. Close the door.
1 minute later, display will return
blank.
2.2. Manual Heating for 2nd Stage
OPERATION DISPLAY
1. Follow step 1 to 4 for 1st stage.
2. Press Power Level pad 2
times.
(Sets MED power)
OPERATION DISPLAY
3. Press 1 ,0,0 pads.
(Sets to 1 minute)
4. Press Start pad. Total time
for both stages will be
displayed.
5. When the 1st stage cooking
time has elapsed, oven beeps
once and automatically
switches to 2nd stage cooking.
(2nd stage)
6. When cooking time has
elapsed, oven beeps 5 times
and shuts off. Display blinks
zero.
7. Open the door and take out the
water load. Display stops
blinking.
8. Close the door.
1 minute later, display will turn
blank.
2.3. Memory Setting for Single
Stage Operation Oven is not in
program lock mode.
OPERATION DISPLAY
1. Press Prog pad.
NOTE: Display must be blank to
start programming.
2. Press 5 pad.
(Sets to memory pad 5)
3. If memory was previously
programmed, the pad number
and the previously selected
time and power level will
appear in the display.
2 OPERATION PROCEDURE
6
NE-1027 / NE-1037