10.
11
Close supervision is necessary for any appliance being
used by
or near children.
Do not leave iron unattended while connected
to
an electrical outlet or on an
ironing board. Always position iron carefully to prevent it from falling if ironing
board is accidentally
bumped
or
if Cord
is pulled.
When not in use,
always place
iron securely into Power Base.
Burns can occur from touching hot metal parts, the hot surface of the Power Base,
hot water, or steam. Use caution when you turn a steam iron upside down-there
may
be
hot water in the Water Tank.
To protect against burns or injury
to
persons,
do
not direct steam toward the
body
when ironing or self-cleaning.
The iron
must be used
and rested
on a
stable
surface. When
placing the iron
into
Power Base, ensure that the surface on which the Power Base is placed is stable.
The AC Power Cord and Plug may present
a
risk of personal injury when the cord is
allowed to retract freely. Always hold the
plug and cord with one hand while
it is
/\)/
o
retracting, and retract the cord slowly
to
reduce the risk of the cord "WHIPPING",
^
^^^^^\\
^
which has the potential risk of causing
injury
to
the face,
eyes, etc..
•
retract slowly
SPECIAL INSTRUCTIONS
A
WARNING
To reduce the risk
of
electric
shock or fire:
1 . Do not operate another high wattage appliance in the same circuit, to avoid a
circuit overload.
2. If an extension cord is absolutely necessary, use a cord rated a minimum of 13
amperes.
Cords rated for less amperage may overheat, and should not be used.
Care should be taken to arrange the cord so that it cannot be accidentally
pulled or tripped over.
""""""""""^
To
reduce the risk of personal
injury and damage
to
your iron:
A
CAUTION
1 . Never
use
steam iron cleaning products in the iron,
as
they may damage working
parts of the iron.
2. Do not use water additives or substitute water such as linen or scented water in
the steam
iron. They
can
stain fabrics.
3. If the Steam/Dry Selector is
not at
Dry position after using, remaining water will
move into the Soleplate and can result in burns when you next use the iron.
4. Don't
use
the Steam or
Jet
of Steam, while
AC
Power
Cord
is unplugged.
Water
will remain inside the
soleplate which will
cause
staining.
Please
do
not
use
Steam or Jet of Steam while Temperature Control Pad is set
to "OFF".
_
3
.
To Next Page
Loading...
