The spray may
be
used with steam or dry ironing.
1
.
Simply pump the Spray Mist Button
whenever
spray is desired.
I.
If the spray doesn't come
out
immediately, keep pumping
until it does
2.
To get
a
finer spray, pump the Button vigorously.
To
get a
more
powerful spray, pump the Button more slowly.
^
For best results, use a quick, full stroke.
HOW TO CARE FOR YOUR IRON
AFTER EACH USE
1 . Press the
"
SET " Pad until the
"
OFF
"
light
turns on.
2. Move the Steam/Dry Selector to Dry Position.
3. Unplug
the iron, retract the
cord slowly.
Always hold
the plug and cord with one hand while
it is retracting.
4.
Empty the water from
the Water
Tank.
DO
NOT store
the iron
with
water inside.
5. Push the Cover
Case
until it clicks to lock.
O
pull
out
5-10
cm
Push the Cover
Case
until you
hear
a click.
MAIN BODY
1
.
When cleaning the main
body
of the iron
,
make sure that iron has cooled down.
2. Wipe the iron with a damp cloth If necessary, use
a
mild detergent.
NEVER
USE
ANY HARSH CLEANERS.
SOLEPLATE
*
Starch and other residue can be easily removed from the Soleplate with a damp cloth.
*
To
avoid scratching the finish,
never use a
metallic
pad
to
clean
the Soleplate, and
never place the
iron
on
a
rough surface.
*
If synthetics are being ironed on a higher temperature level than instructed, not only
will
the
fabric
be
ruined,
but the Soleplate
will often
be covered
with
the
melted remains
of the
synthetic fabric.
*
The best way to remove synthetic residue from the Soleplate is to iron over an old
cotton rag after heating the iron.
A
CAUTION
Never
use
steam iron cleaners in the iron since it may
cause
damage
to
the inside of the iron.
If
the
Power
Cord
is
damaged, it must only be replaced by a special cord.
The iron must
only
be used with the
Power
Base provided.
-10-
To Next Page
Loading...
