NOTE: Do not touch the fabric with the iron. Keep the iron slightly over the fabric to
prevent burns or disfiguring.
Jet
of
Steam can be provided
by
pumping the
"
Jet of Steam Button
".
Set temperature at " HIGH
"
level.
To avoid hot water from dripping out of the Soleplate, please give 5 seconds
of interval
time
before re-pumping
2. Vertical Steam
To
get better
results
when using
vertical
steam, hang
the garment
on a clothes hanger.
Curtains
and drapes may also be steamed once they're hung. Hold the iron away from your body, close
to but
not touching the
fabric.
Pull
the
fabric tight with your free
hand
and
pump
the Vertical
Steam Button (Jet of Steam Button) at 5 seconds intervals as you pass the iron over the
wrinkled
fabric.
A
WARNING
Never iron clothes on the body or point your iron at anyone when steaming.
Keep
hands and
body away
from
steam
areas while using vertical steam feature.
3. Anti-Drip
System (
Automatic Water Seal
)
This model
has an
Anti-Drip System. When the temperature of
the
Soleplate's surface drops
below 250T(121
'C),
the valve for the vaporizing chamber in the iron automatically closes
and stops the water from going in further. This prevents hot unvaporized water from spitting
out from the soleplate when the iron has
cooled
down. With this
System, it
is unnecessary
for
you to
wait until the inside of the vaporizing chamber dries completely when you store
the iron.
NOTE: It is not
a
sign of malfunction when
you
hear
a
clicking sound.
This sound
can be
heard whenever this
System
is activated.
4.
Automatic Shut-Off
The Automatic Shut-Off System provides you with a visible warning signal before the iron
automatically shuts off. The iron will automatically shut itself off if the iron has been left on
the Power Base longer than 10 minutes. 10 seconds before the actual shut-off, the
"
OFF "
indicator will
start
blinking rapidly.
If
the iron
is not moved
during the
warning, the
heater
in
the
iron's Soleplate will automatically
shut
off.
The Automatic Shut-Off System activates only after the temperature reaches its selected level.
To
reheat
your iron after it automatically shuts
off, simply
push
"
SET
"
Pad
until the
red light
appears at the desired temperature indicator.
"
OFF
"
light(green) remains on after your iron automatically shuts
off
.
This
light indicates
that
the iron
is
still plugged
into
the electrical
outlet and voltage is
being
supplied to the Power
Base.
5.
Spray
Note:
Before using
the spray feature, check the
fabric
label
for ironing
instructions because
some
fabrics may be
spotted
or stained with moisture.
The spray feature is particularly helpful for removing stubborn wrinkles and where extra
dampening is needed.
-9-
To Next Page
Loading...
