Panasonic NI-L70SR

See
section
"
HOW TO CONTROL TEMPERATURE
"
and the
following
charts:
Temperature Level Steam/Dry Selector Position
LOW
MtU
HIGH
Dry
(Non-Steam)
Regular
Steam
5. Hold the iron horizontally and move the Steam/Dry Selector into the desired steam position
after
the Temperature Control light turns
on continuously.
You
can
then
start
ironing.
Note:
Anti-Drip System will activate when the temperature of the Soleplate's
surface
drops. At
the
same
time, the steam will stop; it is not a sign of
malfunction
when
you
hear
a
clicking sound.
In this situation, you have to put
your
iron back on
the Power
Base
to reheat.
HOW
TO
USE
AS A DRY
IRON
1 . Move the Steam/Dry Selector to the Dry position.
2. Plug the cord into a standard 120V-60Hz electrical outlet.
3. Set the iron on the Power Base securely. The green
"
OFF
"
light will turn on.
NOTE: If the green light
does not turn
on, replace the iron on
the
Power
Base again, or
the Temperature Control Pad
cannot
function.
4. Push the
"
SET "
Pad until the
red
blinking light
reaches your
desired temperature
level.
Wait until the Temperature Control light turns on continuously. You can then start ironing.
SPECIAL
FUNCTIONS
1 . Jet of Steam
The"Jet of Steam"feature provides extra steam which goes deep into the garment and
is helpful for removing stubborn wrinkles. The
"Jet
of
Steam"
feature
operates
properly
only in the
"HIGH"
indication area of the
"SET"
Pad when
steam
or
dry
ironing
( If used
at
lower setting, water spotting will occur
because the
iron
is not hot
enough
to
change
water to
steam
).
If
you
have not
used
the
"
Jet
of
Steam
"
feature for a
long time,
it is
necessary to clean the inside of the iron before using this feature on any clothes to be
ironed. Simply test the "Jet of Steam" feature several times away from the ironing board
and clothes to be ironed. This will prevent brown spotting or water spotting on the clothes.
1 . Fill iron with water.
See
section
"
HOW TO FILL WITH WATER
".
2. Plug the cord into a standard 120V- 60Hz electrical outlet.
3. Set
the iron on the Power Base
securely.
The green
"
OFF
"
light will turn
on.
4. Push the
"
SET
"
Pad
to
the
"
HIGH "
temperature level. The red light starts blinking.
5. Preheat the
iron until
the
light
turns on continuously, usually
about
1-2
minutes.
6.
Simply
pump the
"
Jet of Steam Button
"
when steam is desired. Pump the
"
Jet
of
Steam
Button
"
several times at the beginning of each ironing session.
7.
Allow
at
least
5
seconds between
uses
of "Jet of
Steam
Button
"
to prevent water spotting.
Use a
press cloth if necessary.
-8-