Panasonic NI-W810CS

HOW TO FILL WITH WATER
A WARNING
Be sure the iron is unplugged from the electrical outlet before filling with water.
1. Move the Steam/Dry Selector to the Dry position to avoid water leakage.
Open the Water Fill Opening. Hold the iron as shown and fill the
iron with water up to" MAX " line (about 7.7 ounces/200ml). (
Use a cup for filling (see Note). r W$U
2. Do not overfill. Check for the correct water fill
level with the iron in the vertical position.
3. C l o se the Water Fill Opening, or water will splash
from Water Reservoir when ironing.
Note:
"MAX" L
Line r
indication
Most tap water can be used in this iron. If water is very hard, distilled or demineralized
water should be used. Do not use water processed through home water softening systems
because this water contains minerals that may be harmful to the iron. Do not use water
additives or substitute water as linen or scented water in the steam iron. They can stain
fabrics or damage the iron.
HOW TO USE AS A STEAM IRON
1. F ill the iron as described in " HOW TO FILL WITH WATER
A CAUTION
Do not overfill the Water Reservoir. The steam will release through the vents when the
iron is positioned vertically.
2. Position the iron vertically and be sure the Temperature Selector Dial is set to 1 1 Off".
3. Plug the AC Cord into the electrical outlet.
4. Set the Temperature Selector Dial to the steam zone (" Wool" to " Linen").
5. Preheat the iron until the indicator light goes out, usually after about 1-2 minutes.
This light will go on and off while ironing to indicate the temperature chosen by the
Temperature Selector Dial is being maintained.
6. Hold the iron horizontally and move the Steam/Dry Selector into the steam position.
Steam/Dry Selector is regulated as follows.
- 6 -