Panasonic NI-W810CS

Off ^
'Steam Zone
7. Whenever the iron is positioned vertically, the steaming
action will stop.
A CAUTION
Do not use the Steam/Dry Selector unless the iron is sufficiently hot to produce steam.
Water will leak out through the vents instead.
While using, the Auto-Valve System will activate when the temperature of the soleplate's
surface drops. At the same time, the steam will stop. It is not a sign of malfunction when
you hear a clicking sound. (NI-W810CS/W750TS Only)
The Thermostat Operating Indicator Light will go on, wait until the Thermostat Operating
Indicator Light goes out.
HOW TO USE AS A DRY IRON
1. Move the Steam/Dry Selector to the Dry position.
2. Position the iron vertically, set the Temperature Selector Dial to " Off".
3. Plug in the iron.
4. Set the Temperature Selector Dial to the desired position.
(Refer to the FABRIC IRONING CHART on page 12)
5. Preheat the iron until the Indicator Light goes out, usually about 1 -2 minutes.
- 7 -