Panasonic NI-WL600

HOUSEHOLD USE ONLY
SAFE USE OF THE IRON _
Your safety and the safety of others are very important
We have provided important safety messages in this manual and on your appliance.
Always read and obey all safety messages.
A This is the safety alert symbol. It is used to alert you to potential hazards
that can kill or injure you and others. The safety messages will follow the
safety alert symbol and either the word" WARNING " or" CAUTION ".
These words mean:
T _ _ _ _ This describes issues which
| p° u l d cause death or serious
T _ __ _ _ I This describes issues which
/l\ tZ M could cause injury or damage
lIj | your belongings.
The safety messages will tell you what the potential hazard is, how to reduce
the chance of injury, and what can happen if the instructions are not followed.
Thank you for buying a Panasonic Iron
Your iron is an appliance to be used only for ironing fabrics on an ironing board.
IMPORTANT SAFETY INSTRUCTIONS"
When using your iron, basic safety precautions should always be followed,
including the following:
READ ALL INSTRUCTIONS BEFORE USING THE IRON
To reduce the risk of burns,
electric shock, fire, or injury
to persons:
1. Use the iron only for its intended purpose, for ironing fabrics on ironing board.
To protect against burns or injury to persons, do not iron or steam fabrics while
being worn on the body.
2. To protect against the risk of electric shock, do not immerse the iron or cord in
water or other liquids.
3. The iron should always be turned to" OFF" before plugging or unplugging AC
Power Cord from outlet. Never yank Cord to disconnect from outlet; instead,
grasp Plug and pull to disconnect.
4. Do not allow Cord to touch hot surfaces. Let iron cool completely before putting
away. Bundle AC Power Cord when storing.
5. Always disconnect AC Power Cord from electrical outlet when filling iron with
water or emptying and when not in use. Do not spill water over iron when filling.
6. Do not operate iron with a damaged Cord or if the iron or Power Base has been
dropped or damaged. To avoid a risk of electric shock, do not disassemble the iron
or Power Base, take it to an authorized service depot for examination and repair.
Incorrect reassembly can cause a risk of electric shock when the iron is used.
- 2 -
A WARNING