14
English
►METHOD(2) Using the “Power Shot” feature
1. Repeat steps 1 to 4 as described in “METHOD(1)”.
2. Hold the iron horizontally over the sink after the Thermostat Operating
Indicator Light has gone out.
3. Pump the Power Shot Button quickly (at least 3 times
per second) about 20-30 times.
While pumping, tilt the iron up and down slowly to
help clean the entire Water Tank and let the water drip
out of the Soleplate vents.
4. To prevent corrosion of the Soleplate vents, after the
Soleplate has cooled, set the Power Switch to “ ”
and preheat for about 5 minutes.
5. Unplug.
• Do not store the iron with water in the Water Tank.
6. Iron on a used cloth to remove any impurities on the Soleplate.
• Repeat METHOD(1) and METHOD(2) if the iron still contains a lot of
impurities.
• Use both methods once every two weeks. If the water is very hard (i.e. Steam
holes on the Soleplate are easily blocked by impurities), both methods should
be used more frequently.
• Let the iron cool down on its Heel Rest and follow the instructions “After
each use”.
►METHOD(3) Anti Calc System (Stay Clean Vents)
The built-in Anti Calc System in the Water Tank continuously reduces scale build
up in the vaporizing chamber of the iron.
This system makes it possible to use the steam function for a long period of
time and prevents steam vents from clogging.
Anti-drip system (automatic water seal)
This model has an Anti-Drip System. When the temperature of the Soleplate’s
surface drops to low, the valve for the vaporizing chamber in the iron
automatically closes and stops the water from flowing. This prevents hot
unvaporized water from spewing out from the Soleplate when the iron has
cooled down. With this System, it is unnecessary for you to wait until the inside
of the vaporizing chamber dries completely when you store the iron.
Note
• It is not a sign of malfunction even a click sound is heard. This sound can
be heard whenever this system is activated.
To Next Page
Loading...
