15
English
How to care for your iron
►After each use
1. Set the Power Switch to “ ”.
2. Unplug.
3. Set the Steam/Dry Selector to the Dry position. If the
Steam/Dry Selector is not in the Dry position after
using, remaining water will move into the Soleplate
and can result in burns when the iron is used next time.
4. Empty the Water Tank immediately after using. Do not
store the iron with water in it. If you empty the
Water Tank after it has cooled, heat the iron for
about 5 minutes with the Power Switch set to “ ”.
• Do not use the Steam or the “Power Shot” while
unplugged or the Power Switch is set to “ ”,
water will remain inside the Soleplate and cause
staining.
• Do not wind the Power Cord around the iron. It may be damaged by the
hot Soleplate.
Electronic 3-way auto shut-off function (NI-WT980 only)
1. When the iron is left idle with its Soleplate facing down or on its side
for approx. 1 minute, the iron will automatically shut off.
2. When the iron is left idle on its Heel Rest for approx. 10 minutes,
the iron will automatically shut off.
3. To resume ironing and turn the iron on, simply move the iron.
Allow the iron to reheat until the Thermostat Operating Indicator
Light switches off.
Always unplug the iron when you finish ironing. Even though the Iron is
unplugged, the soleplate is still hot. Be sure to rest the iron on its heel,
away from fabric.
・The Auto Shut-Off feature is not intended to take the place of unplugging the
cord. The Auto Shut-Off system works regardless of the position of the Power
Switch.
1 minute
1 minute
10 minutes
To Next Page
Loading...
