4. Remove 1 screw holding back cover on the lower of back
plate, then remove back cover.
5. Disconnect 4 lead wires from 2 thermal cutouts and
convection motor terminals respectively.
6. Remove 10 screws holding convection outside cover B on
cavity back plate, then remove the module, which consists
of convection inside cover A, convection motor and
convection heater.
To replace convection heater
7. Remove 1 nut holding convection fan, then remove
convection fan.
8. Remove 2 screws holding convection fan bracket on
convection inside cover A.
17
NN-CF771S
To Next Page
Loading...
