4.3. Low voltage transformer
and/or power relays (RY1)
NOTE:
Be sure to ground any static electric charge built up on
your body before handling the D.P.C.
1. Replace D.P.C. board.
(A) Using solder wick or a desoldering tool and 30W
soldering iron carefully remove all solder from the terminal
pins of the low voltage transformer and/or power relays.
NOTE:
Do not use a soldering iron or desoldering tool of
more than 30 watts on D.P.C. contacts.
(B) With all the terminal pins cleaned and separated from
D.P.C. contacts, remove the defective transformer/power
relays, Replace components making sure all terminal pins
are inserted completely resolder all terminal contacts
carefully.
4.4. Fan motor
1. Disconnect 2 lead wires from fan motor terminals.
2. Remove 1 screw at location on oven attaching orifice
assembly.
3. Remove orifice assembly from oven assembly.
4. Remove 2 screws holding fan motor to oven.
5. Remove fan blade from the fan motor shaft by pulling it
straight out.
11
NN-CT585S / NN-CT565M / NN-CT555W
To Next Page
Loading...
