Panasonic NN-SD377S - Table of Contents

1 SCHEMATIC DIAGRAM 4
1.1. APH
4
1.2. CPH
5
2 CAUTIONS TO BE OBSERVED WHEN TROUBLESHOOTING
6
2.1. Check the grounding
6
2.2. Warning about the electric charge in the high voltage
capacitor
6
2.3. When parts must be replaced, remove the power plug
from the outlet.
6
2.4. When the 15 Amp fuse is blown due to the operation of
short switch:
6
2.5. Avoid inserting nails, wire, etc. through any holes in the
unit during operation.
6
2.6. Confirm after repair
6
3 MEASUREMENTS AND ADJUSTMENTS
7
3.1. Adjustment of primary latch switch, secondary latch switch
and short switch.
7
3.2. Measurement of microwave output
7
4 PROCEDURE FOR MEASURING MICROWAVE ENERGY
LEAKAGE
8
4.1. Equipment
8
4.2. Procedure for measuring radiation leakage
8
4.3. Record keeping and notification after measurement
8
4.4. At least once a year, have the radiation monitor checked
for calibration by its manufacturer.
8
5 EXPLODED VIEW AND PARTS LIST
9
5.1. EXPLODED VIEW
9
5.2. PARTS LIST
10
5.3. DOOR ASSEMBLY
11
5.4. WIRING MATERIALS
11
5.5. ESCUTCHEON BASE ASSEMBLY
12
5.6. PACKING AND ACCESSORIES
13
6 DIGITAL PROGRAMMER CIRCUIT
14
6.1. SCHEMATIC DIAGRAM
14
6.2. PARTS LIST
16
CONTENTS
Page Page
3
NN-SD377S