Panasonic NR-B30FG1 - Case Sw A’ssy; Disassembly of Case SW Assy; Sensor Sc A’ssy and Damper Thermostat

36
11.2.4. SENSOR SC A’SSY AND DAMPER
THERMOSTAT
1. Separate INS Duct VCT and INS Duct VCB
• Tear off crepe tape, separate INS Duct VCT and INS
Duct VCB.
2. Remove each parts
• The point of replacement of Damper Thermostat.
a. Take Damper Thermostat out from INS Duct, pull
the connector out.
b. Replace Damper Thermostat.
• The point of replacement of Sensor SC A’ssy.
a. Take Damper Thermostat out from INS Duct, pull
the connector out.
b. Replace Sensor SC A’ssy.
NOTES
1. Put heat insulator on around Damper Thermostat as
before, after connect the connector with it
2. Install Damper Thermostat securely. It might become
cause of leakage of cooling air.
3. Put crepe tape on joint parts, after assembly INS Duct
VCT and INS Duct VCB.
4. Fix Sensor SC A’ssy to the hook of IND Duct VCT as
before.
11.3. Disassembly of CASE SW
A’SSY
11.3.1. CASE SW A’SSY
1. Insert screwdriver (-) in a gap of the triangle mark
portion of Case SW A'ssy then pry off Case SW A'ssy.
NOTES
• Be careful not to make a scratch by screwdriver (-) to
the paint work of Center Crossrail.
• Please put a tape on the part where a screwdriver (-)
touch to prevent paintwork in the Center Crossrail
being damaged.
2. Remove two connectors.
• Do not pull wire so strongly to remove the connec-
tor. The connector can be taken out while pressing
the hook.
NOTES
• The connector is classified by the color. Connect
those connectors as before so as not to make mis-
take.
• Be careful not to bite wires between Case SW A'ssy
and Center Crossrail when you install Case SW
A’ssy.