42
when you install it in INS Cover Coil.
• Install Fan Motor FC A’ssy in INS Cover Coil. It might be
cause vibration, abnormal sound, in case of imperfect
installation of Fan Motor FC A’ssy.
• Tighten Bag Joint that is put in the connector of Fan
Motor FC A’ssy with other connectors by Cable Tie as
before.
• Insert Cover Connector FC in upper side of FC as
before, screw the screw that is fixation of it.
NOTES ON INSTALLATION OF COVER COIL FC A’SSY
• Install Cover Coil FC A’ssy in upper side of depths of
FC, then fix it by three screws.
• It might be cause of getting frost, in case of imperfect
installation of Cover Coil FC A’ssy.
11.5. Disassembly of PCB (Panel),
Button Control Assy
11.5.1. PCB (Panel), Out Door Control
A’SSY
1. Insert screwdriver (-) into the gap between Out Door
Control A’ssy and Door A’ssy PC. Then pry off Out
Door Control A’ssy.
NOTICE
• Please put a tape on the part where a screwdriver (-)
touch, to prevent paintwork in the Door A’ssy PC being
damaged.
2. Pull the connector of PCB (Panel) out while pressing
the hook, and take it out from Door A’ssy PC.
3. Remove the screw that is fixation of PCB (Panel), and
unhook six hooks of PCB (Panel). Then take PCB
(Panel) out from Button Control.
NOTICE
• Be careful not to break PCB (Panel) when it is removed
and installed. It might become cause of defective opera-
tion.
11.6. Disassembly of PCB Control,
PCB Inverter
11.6.1. PCB Control, PCB Inverter
1. Remove + screw and Torx screw, and remove the
Cover PCB Assy.
2. Disconnect the connectors, and unscrew the screw
of right side of each PCB.
Remove each PCB, while unhooking the hooks.
CAUTION
Be careful not to touch directly electric parts on the
PCB when you remove and install each PCB.
To Next Page
Loading...
