Panasonic NR-B30FX1 - Cover Coil Fc

38
2. The lid (color painted) of the Scotch Lock is crimped
with pliers. Then the lid height become in the same of
the body height of the Scotch Lock
• When you crimp the Scotch Lock with pliers, please
work while holding these wires to the Scotch Lock
side so that these wires should not come off.
3. Check good operation or not those parts after the
work.
CAUTION
Be careful not to bite the wires by Cover Sensor, when
store the wires and the Scotch lock in Cover Sensor.
11.4.2. COVER COIL FC
1. Take Case FCT Assy and Case FCB A’ssy out of FC.
2. Take Glass Tray FCT and Glass Tray FCB out.
a. Remove the screws that are fixation of Holder
Glass FC. (Each of two FC right and left)
b. Remove Holder Glass FC and pull Glass Tray FCT
and Glass Tray FCB out.
• The figure is left side view also there are Holder
Glass R in the right side.
3. Take Cover Connector FC out
a. Remove the screw that is fixation of Cover Con-
nector FC on the left of upper side of FC.
b. Pull Cover Connector FC toward you, unhook the
Hooks(4 portions).
c. Remove sensor FC from the hook of reverse side
of Cover Connector FC, pull out the connector for
Fan Motor FC.
4. Remove Cover Coil FC A’ssy
a. Remove three screws in front of Cover Coil FC
A’ssy.
b. Remove Cover Coil FC A’ssy while pulling bottom
side.