Panasonic NR-B30FX1 - Exchange Stopper Door & Latch Door; Remove Door A’SSY FC

45
CAUTION
• Be careful not to forcibly bend when the connector is
through the hole of Hinge Top R. Because it might be
cause to wire cut or connector damage.
• Please do removing and installation work of Hinge
Top R by two persons, the person who has Hinge
Top R and the person who has Door A'ssy PC, in
total. Because it might be cause of dropping acci-
dent of Door A'ssy PC.
4. Remove Door A’ssy PC from Hinge Center R while lift-
ing the door.
11.8.2. Remove Door A’SSY FC
1. Remove Hinge Center R
a. Open Door A'ssy FC, and remove two screw that
are fixation of Hinge Center R.
b. Remove Hinge Center R and Shim Hinge FCT.
c. Remove Cap Hinge Pin FCT.
2. Remove Door A’ssy FC from Hinge Bottom R while
lifting the door
3. Remove Hinge Bottom R
• Remove two screws that are fixation of Hinge Bot-
tom R.
• Remove Hinge Bottom R.
11.8.3. Exchange Stopper Door & Latch
Door
1. Exchange Stopper Door & Latch Door of Door A’ssy
FC
a. Turn the Door A’ssy FC upside down first. Remove
the two screws that are fixation of Latch Door R of
under side of Door A'ssy FC, then remove Stopper
Door and Latch Door R.
(Stopper Door and Latch Door R are disused.)
b. Put Latch Door L upon Stopper Door L, fix
securely on left side of bottom of Door A’ssy FC.
by the two screws that were removed above (1).
2. Exchange Stopper Door & Latch Door of Door A’ssy
PC
• Do in the same work as before “Exchange Stopper
Door & Latch Door of Door A’ssy FC”.