32
10.4. Replacement of Refrigerator
Sensor
1. Remove the refrigerator sensor cover by pulling forward.
2. Remove the sensor by hand.
3. Remove the sensor connector. Connect the new sensor,
place the sensor in cover and reattach the cover.
10.5. Replacement of Freezer Multi-
flow Cover
1. Remove caps and unscrew the 4 screws shown at the
picture.
2. Then pull multiflow cover slightly from the bottom.(In case
of icing between cover and evap, do not pull the cover
with full force, slightly shake the cover to brake the icing
then pull.)
To Next Page
Loading...
