1. SAFETY CAUTION FOR REPAIRING
When you repair the refrigerator, please kindly take care for the following cautions
1.1 Warning
Before repairing unit, unplug supply cord
•
Before you repair the refrigerator, please unplug the supply cord
Use authentic parts when replacing
•
When you replace the parts, please use authentic parts to replace defective parts.
Caution during brazing
•
When you use touch for brazing, please ensure ventilation.
Otherwise, you will be poisoned by carbon monoxide.
Pay attention to using refrigerant
•
If refrigerant touches fire, the gas becomes poisonous gas.
Pay attention to getting electricity shock
•
When you check the voltage of terminal, please do not touch the electricity part terminal.
•
When you replace the parts, please wait for 3 minutes at least for discharging capacitor.
Check safety after repairing
•
Check the screws, parts, lead wires to take in place.
•
Check the repairing portion whether circumferential parts are damaged or not.
•
Check insulation resistance between supply plug and earth.
•
When install refrigerator, check condition of supply cord and plug.
•
Wipe off the dust on plug.
•
Cutting and seal the electric device carefully.
1.2 Caution
Watch the hot parts
•
During operation and after operation, compressor and pipes are hot.
•
Also, under these condition, heater are hot.
•
Do not burn your fingers when you touch it.
Pay attention to refrigerant
•
Do not touch liquid refrigerant. Otherwise your hands may be burnt.
Pay attention to edge of parts
•
Otherwise, your fingers may be cut.
Pay attention to fins of evaporator and condenser
•
Otherwise, your fingers may be cut.
Before transportation, adjust the bolt
•
Otherwise, the floor may be damaged.
Do not touch the pipe after brazing
•
Otherwise, your hands may be burnt.
To Next Page
Loading...
