Panasonic NR-BV328 - Disassembly Instruction; Disassemble Door Control AS. (X series)

6.1. Disassemble DOOR CONTROL AS.- X series
① DOOR CONTROL AS. on
② Use small knife, take out from the upper right side of DOOR
CONTROL AS.
④ Take out 1 connector then disassemble DOOR CONTROL AS.
③ Take the hook along on
DOOR CONTROL AS. by
shaking well on both sides.
⑤ Take out 1 screw on circuit
board
⑥ Push on the open hook and
keep the circuit to take PAS-
OPERATION PCB(DOOR) out
Connector
screw
⑦Use small knife to separate
HOLDER BOARD and
ESCUTCHEON
1. PAS-OPERATION PCB(DOOR)
2. ESCUTCHEON CONTROL
3. HOLDER BOARD
1
2
3
6. DISASSEMBLY INSTRUCTION
8