6.2 Disassemble PC DOOR
6.3 Disassemble LED light
6.4 Disassemble COVER DUCT PC AS.
COVER HINGE TOP
② Use flat head rod to pull
COVER HINGE TOP
out
Disassemble connector
④ Remove 3 screws, take out
the HINGE TOP and then
disassemble the PC DOOR
screw
Notice: Apply grease to the areas
of circles of hinge center
① Use flat head rod to loosen
at 3 hook position to take
COVER LED out
② Undo connector and remove
PAS-
LED PCB at the position of
hook
① Position of COVER DUCT
PC AS.
screw cover
②
Use flat head rod to open
screw cover
③ Take out 3 screw then
remove COVER DUCT PC AS.
To Next Page