15
Using the Viewfinder/LCD Monitor
ª Using the Viewfinder
Before using the Viewfinder, adjust the field of view so that the
displays inside the Viewfinder become clear and easy to read.
1 Pull out the Viewfinder and tilt it up.
2 Adjust by sliding the Eyepiece Corrector Knob 1.
≥Do not pull hard on the Eyecup.
ª Using the LCD Monitor
With the LCD Monitor open, you can also record the picture
while watching it.
1 Put the finger on the [OPEN 4] Tab 2 on
underside of the LCD Monitor and pull it out about
90o in the direction of the arrow.
≥The Viewfinder goes off.
2 Adjust the LCD Monitor angle according to the
desired recording angle.
≥The LCD Monitor can rotate a maximum of 180o 3 from
the vertical position to the upward direction and a
maximum of 90o
4 to the downward direction. Forcefully
rotating the LCD Monitor beyond these ranges will damage
the Movie Camera.
Closing the LCD Monitor
Push the LCD Monitor until it is securely locked.
ª Adjusting Brightness and Colour Level
When [LCD/EVF SETUP] on the [CAMERA FUNCTIONS] or
[VCR FUNCTIONS] Main-Menu is selected, the following items
are displayed. (l 16)
LCD Brightness [LCD BRIGHTNESS]
It adjusts the brightness of the image on the LCD screen.
LCD Colour Level [LCD COLOUR]
It adjusts the colour saturation of the image on the LCD screen.
Brightness of the Viewfinder [EVF BRIGHTNESS]
It adjusts the brightness of the image in the Viewfinder.
To Adjust
Press the [PUSH] Dial and select the item to be adjusted, and
then turn the [PUSH] Dial to raise or lower the number of vertical
bars in the Bar Indication.
≥A larger number of vertical bars indicates stronger brightness
or colour saturation.
≥For other notes concerning this item, see page 57.
12:30:45
15.10.2003
12:30:45
15.10.2003
12:30:45
15.10.2003
12:30:45
15.10.2003
34
2
180x 90x
PRESS MENU TO RETURN
LCD/EVF SETUP
LCD BRIGHTNESS
[-]||||----[+]
LCD COLOUR
[-]||||----[+]
EVF BRIGHTNESS
[-]||||----[+]
1
1
2
1
2
1
B-Eng.book 15 ページ ２００３年２月１４日 金曜日 午後２時４３分
To Next Page
Loading...
