47
WEBCAM: PC connection mode
(in Camera mode or VCR mode)
STORAGE: PC connection mode
(in Card playback mode)
00: Remaining Number of Card
Photoshot pictures (l 41)
100-0001: DCF Number (l 42)
D-001: Number of prints set by DPOF
(l 45)
1(white): File Number ([640k480] Image
size) (l 42)
1(green): File Number ([320k240] Image
size) (l 42)
¥: DPOF Setting completed (l 45)
640: [640k480] Image size
≥For images not recorded with this Movie
Camera, the size display is determined as
follows according to the number of horizontal
pixels.
320: [320k240] Image size
640: From 640 to 800 (The size is not
displayed at under 640 pixels.)
SVGA: From 800 to 1024
XGA: From 1024 to 1280
SXGA: From 1280 to 1600
UXGA: Over 1600
ª To Change the Counter Display
Mode
By changing [C.DISPLAY] on the
[DISPLAY SETUP] Sub-Menu, you can change
the Counter Display Mode to Tape Counter
Indication [COUNTER] (0:00.00), Memory
Counter Indication [MEMORY] (M0:00.00), and
Time Code Indication [TIMECODE]
(0h00m00s00f). (l 17) By repeatedly pressing
the [COUNTER] Button on the Remote Controller,
you can change the Counter Display Mode.
ª To Display Date/Time Indication
To display Date/Time Indication, set the
appropriate Date/Time in [DATE/TIME] on the
[DISPLAY SETUP] Sub-Menu. (l 17)
You can also press the [DATE/TIME] Button of the
Remote Controller repeatedly to display or change
the Date/Time Indication.
ª To Change the Display Mode
By changing [DISPLAY] on the [DISPLAY SETUP]
Sub-Menu, you can change the Display Mode to
All Function Display [ALL], Partial Display
[PARTIAL], and Minimum Display [OFF].
Warning/Alarm Indications
If any one of the following indications lights up or
flashes, please check the condition of the Movie
Camera.
≥Some Indications may not be displayed
according to the model.
3: Condensation has occurred. (l 54)
Y: The accidental erasure prevention
slider on the inserted Cassette is
open (that is, set to [SAVE]).
You are about to do audio dubbing
on the unrecorded (blank) portion
of the tape.
No Cassette is inserted. (l 14)
6: The Battery is low. Recharge it.
(l 12)
0: The button-type battery is
discharged. (l 19)
:: The video heads are dirty. (l 55)
2END: The tape came to end during
recording.
REMOTE: Wrong Remote Controller Mode
has been selected. (l 48)
UNPLAYABLE TAPE (OTHER FORMAT):
You are attempting to play back a
tape section that has been
recorded with a different TV
system.
UNABLE TO A. DUB (LP RECORDED):
Because the original recording was
done in LP Mode, audio dubbing
cannot be performed.
INCOMPATIBLE TAPE:
This Cassette is incompatible.
CARD LOCKED:
When you are attempting to write
the data on an SD Memory Card
whose write protection switch is set
at [LOCK].
FILE LOCKED:
When you are attempting to delete
a locked picture. The locked picture
cannot be deleted.
NO SPACE LEFT:
Card does not have sufficient
memory remaining.
CARD FULL: Card does not have sufficient
memory remaining.
NO CARD: Card is not inserted.
NO PICTURE:
Card has no pictures recorded on it.
B-Eng.book 47 ページ ２００３年２月１４日 金曜日 午後２時４３分
To Next Page
Loading...
