Panasonic NV-HD675 Series - Setting Remote for TV Control

16
You can operate the TVs of the manufacturers listed below
with the remote controller after setting it.
01
02
03
04
05
06
07
08
09
10
11
12
13
14
15
16
17
18
19
Setting
the
Remote
Controller
for
Operation of your TV
Set VCR-—TV switch to TV for using POWER ©, the
Y and A buttons and the numeric buttons.
Panasonic/National
Panasonic/National
Panasonic/National
Panasonic/National
SONY
TOSHIBA
JVC
HITACHI
MITSUBISHI
MITSUBISHI
SHARP
PHILIPS, SAMSUNG
NEC
SANYO
GOLDSTAR
GOLDSTAR
SAMSUNG
SAMSUNG
SANYO,
This setting procedure allows you to operate the TVs of
some manufacturers using the supplied remote controller.
Preparation
Set the VCR--TV switch to TV.
Operations
1 Find the manufacturer number of your
TV while referring to the following
table.
GCC HHHSHERUSECHADOH LESTE BOR OHOD
2 While holding down POWER (5, use
the numeric buttons to enter the
manufacturer number. This completes
the settings for the TV manufacturer.
© Be sure to enter the number in two digits.
Example: 101
Sy OT HHEERGCTHH FOF THOHRHOHHOHMHRAEOXBEOD
3 To confirm that the correct settings
were made, check whether the TV can
be operated properly.
@ When a manufacturer has multiple numbers in
the following table, try entering other numbers if
the TV operations cannot be performed properly,
and then select the optimal number.
FOKRGCHFOOHFHOH GHA HOH HAH OKHLHH OHS OD
Notes:
@ If you are using a Panasonic TV, this setting has already
been made, and so you do not need to perform the above
setting procedure. However, this remote controller may
not work with some Panasonic TVs.
® Some TV models cannot be operated using this remote
controller (including all TVs non-remote compatible).