Panasonic NV-SD430 Series - Changing the RF Output Channel

How to Change the RF output Channel
(using the remote controller)
In some rare cases after tuning the TV to your VCR,
interference may be visible on the picture. To get rid of this
interference, you can manually adjust the RF output channel
a few channels up and down from the current setting. The
procedure is described below.
Operations
1 Hold down MENU for 5 seconds or more.
@ The VCR dispiay changes as shown on the right and
the VCR picture on the TV displays this pattern.
Example for Example for
NV-SD430A NV-SD430EA
EXD
2 Enter the desired channel number (AU28-69, NZ2 or 3) by
using the numeric buttons or the VY and A buttons.
@ Ensure that VCR/TV switch is set to VCR.
© Set the RF output channel of the VCR to “-~" (RF
OFF) when the VCR is connected to the TV via the
AUDIO VIDEO cable. (NV-SD430A only)
Press the V and A buttons to display “——”.
For NV-SD430A For NV-SD430EA
cea a ame 2-——+3
(RF OFF)
Example:
28; () ~@ ~@® “
Vv
(Use only the V and A buttons for NV-SD430EA.)
3 Press MENU to finish the setting mode.
4 Retune your TV to the new AF channel for the VCR.
Note:
Even if the RF output channel has been changed, it is not
necessary to perform the TV station search.
Q.
~
D
s
®
Y)
LE