Panasonic NV-SD430 Series - G-Code Programming

G-Code Programming
Programming is now easier than ever; simply enter the G-
Code number found in the programme scheduling pages of
newspapers and magazines.
G-Code numbers are numbers assigned to programmes
listed in the TV programme schedule found in newspapers
and TV guides. When these numbers are entered, the
numbers are converted to actual programming.
Preparations
@ Insert a video cassette tape with an intact erasure
prevention tab.
© Confirm that the TV is on and the VCR viewing channel is
selected.
@ Turn on the VCR.
© Check that the clock is set to the correct time. If it has not
been set, refer to page 17.
@ Press VCRITV to select the VCR mode.
(NV-SD430EA only)
Set VCR/TV switch to VCR for using the
numeric buttons and the G-CODE button.
(INDEX 2° REC.
oO Bee.
& =
aa a oa [Se DATE ONO 7
5 ‘aaa fama Tier EY
Operations
On
Screen
Display
oo
75
FFF
OSB
OCH
RTE
OO
RHO
REO
ROBAHO
1 Press G-CODE.
eEnsure that VCR/TV switch
is set to VCR.
G-CODE
Co
@eoaooxs
os
ae
oe
eoeoeeoeeovea
aoe
958
2 Enter a G-Code number.
Example: 123456
120456-——
elf you have entered the wrong number, press
CANCEL then enter the proper number, An
alternative
method
is
to
press
«4
and
then
enter
the
proper number.
@OSOHTGO
HTH
OM
OF
OH
ROHR
OOMRH
AKAD
3 Press ENTER.
Confirm
that
the
number
corresponds
to
the
right
programme.
If
the
display
looks
like
this:
select
the
programme
position
of
your
VCR
which
receives
the
TV
station
you
entered
at
step
2
using
the
@
(CH)
then
press
ENTER.
To make any corrections, use
buttons @ (DATE), © (ON) and @ (OFF) the same
way as described on page 28,
Bao FGF CHT HAGF FOO DORE DAH HADOD
4 Press TIMER REC (.
@
69098
S4GCTF>F>O4
FC
ORR
DARTFORD
08
Notes:
© To select the desired tape speed, press SPEED after step
3.
© When the G-Code number is used for programming, the
recording time may be slightly longer than the actual
programme time.
© Repeat steps 2 and 3 if “PROGRAMME IS
INCOMPLETE." appears.
@ When programming two or more programmes, repeat
steps 1-4.
© The procedures for checking and cancelling a timer
programme are the same as on page 29.