仕様概略
Panel Maintenance function-3
3-2. Flow of Panel Maintenance-2 mode (It takes about 80 min.) :There are 2 flows. One is executing manually from Menu.
The other is automatically activated when the TV is turned off with remote control after watching TV for 1000(#) hours or more.
2. TV turns off by remote control after watching TV
for total 1,000(#) hours or more
TV turns off by remote control
Panel Maintenance-1 mode
(for about 10 minutes)
Panel Maintenance-2 mode
(for about 1minute)
Finish
White thin line
LED: Orange lighting
Scan
TV turns off
automatically
(Note)
*1: When the TV is turned off with mains power
switch, this mode is not activated.
*2: If checked “Don’t start… “, this OSD isn’t
displayed when TV turns off until TV is
operated for 1000(#) hours again.
*3: When the TV is turned on during activating
this mode, this mode is stopped and cancelled.
# : It is changed from Last year EZ series (=1500 hours)
*1
Watching TV
For total 1000(#) hours
*2
(Watching time is reset)
82
OLED
The Notification is displayed.
Panel maintenance has been
interrupted. Please start again from
the Panel Maintenance menu.
Panel maintenance
is complete.
(Power on next)
(No display)
Power LED: Orange lighting
Back to normal standby
LED: Red lighting (or Orange）
*North & Latin America models(U/C/X/W) No lighting
If power on before complete. *3
(screen)
If power on after complete.
1. Menu of Panel Maintenance
Main Menu Picture Screen Settings
“Panel Maintenance”
If you have customer complaints for “image retention”, please activate the Panel Maintenance in Menu.
1 hour later
(Because of Panel cooling)
To Next Page
Loading...
