The following are possible broadcast types with their accompanying
on-screen displays. The signal being received is indicated with a" [_" mark
while the selected audio mode is indicated with an arrow. To change the
audio mode for these broadcasts, follow the "Select Audio Mode tot TV
Viewing" section (below.)
DISPLAY =
_STEREO_
_SAP
MONO
STOP 12:OOAM ABC
0:00:00
_STEREO_ SP
SAP
MONO
STOP 12:00AM A_
__0 _ 0;00:00
STEREO SP
Display the broadcast signal
being received.
Press DISPLAY to display.
MT$ Stereo and SAP broadcast
Multi-channel Television Sound Stereo
(main language) and Secondary Audio
Program (sub language) broadcasts are
both being received simultaneously.
Select the STEREO or SAP audio mode.
MTS Stereo broadcast
Multi-channel Television Sound Stereo
broadcast, Select STEREO audio mode.
• Ifstereobroadcastisweakand thedisptay
flickers, select MONO audio mode for
possibly better results.
SAP broadcast
Secondary Audio Program (sub language.)
Select SAP audiomode forthe sub language.
MONO broadcast
Normal monaural sound broadcast.
AUDIO
0
< Example >
Press AUDIO to select the desired
audio mode as described above.
(Arrow shows selection.)
• Each press of AUDIO will change the audio
mode as shown below.
• "SAP" is selected with first press of AUDIO.
%
STOP f2:OOAM ABC /
0:00:00
/
_STEREO SP
SAP
_i_3 _[ STOP 12:0DAM _CO
0:00:0_
_STEREO SP
SAp
MONO _ STOP 12:00AM ABC
0:00:00
-- ISTEREO _ SP
L Press
AUDIO _[
LPrsss _1
- AUDIO _ k
j quipped with A_x® -TV Noise Reduction-
for true MTS reproduction.
.l_x ® -TV Noise Reduction is required for
good stereo separation and audio fidelity.
dbx ® is a registered trademark, and is
licensed by _6x® Technology Licensing.
_CT U_T
(3D GD (_D
CD _D ¢_
_a1_T
_G33
_-'_ =C_' _3_-_- DISPLAY
_3 _; _ _ AUDIO
IMPORTANT NOTE:
<For model PV-C2O60 only>
This stereo system is designed
for TV viewing only. Recording
and playback will always be in
monaural
11
To Next Page
Loading...
