Unhook the antenna from your
previous TV or VCR and connect it to
the back of the unit as shown in the
diagram.
If your antenna system has separate
UHF and VHF lead-ins, you need a
UHF/VHF Band Mixer (net supplied.)
WARNING:
When using "Nut type" RF coaxial
cables, tighten with fingers only.
Overtightening may damage terminals.
UHFNHF Band A [_
Mixer not supplied \_
(Flat)Twin Lead k
300OhmCable I
(Round) 75 Ohm ,-_1 I_
coaxial Cable f_{q_ _/ I _ff11_l l,I
....... or " -.
from_ 300-75 ohm ; "'_
Antenna Transformer i - _"- :
(not suppliec ,
::_I_ Backofunit
(Rat) Twin Lead
300 Ohm Cable <Model PV-C2060unit isshown here>
• Without a Cable Box
You can;
• record or view unscrambled channels.
You cannot;
• record or view scrambled channels.
• view a channel other than the one
selected for any type of recording.
Antenna
or ',
unit
_ -.%
• With a Cable Box _
You can; Antenna
• record or view any channel including scrambled channels. ,I or ,
NOTE: Channel selection must be made at the cable box. CABLE
You cannot;
• view a channel other than the one selected for any
type of recording.
• do a Timer recording of a channel unless you select it
at the cable box.
Note to CABLE System Installer
This reminder is provided to call the CABLE (Cable TV) System
Installers attention to Article 820-40 of the NEC that provides
guidelines for proper grounding and, in particular, specifies that
the cable ground shall be connected to the grounding system of
the building, as close to the point of cable entry as practical.
Cable Box
OUT
• With a DSS Receiver
You can;
• record or view any channel including scrambled
channels.
NOTE: Channel selectionmust be made atthe DSS
Receiver.
You cannot;
• view a channel other than the one selected for
any type of recording.
• do a Timer recording of a channel unless you
select it at the DSS box.
NOTE: The DSSreceivermust beturnedoff to view
programsfrom a cableboxor antenna.Seethe DSS
manualfor details.
Antenna
,; or J
CABLE Y
Satellite
'1
Receiver
IN_
unit
unit
VHF/
UHF
7
To Next Page
Loading...
