Panasonic Omnivision PV-V4611 User Manual

‘Important: If a remote control button does not work when pressed, press
the VCR button on the remote and try the button again.
VCR Plus+ Programming
ready Check List
Clock is set.
D VCR Plus+ Setup is complete (see page 18).
1 [VCA Pis+ [*PAOG. | Tis
DATE START STOP ©
13 SAT moron aero =
TODAY
SELECT: 4 F « >
EXIT : PROG
PVCA Plus+
ENTER PLUSCODE NUMBER
USING 0-9 KEYS
SELECT:4 4 4 >
¿PR
VCH Plus+ | PROG. | LIST]
ENTER PLUSCODE NUMBER
USING 0-9 KEYS
BACKSPACE : q
N
*\f the Pluscode
number entered
begins with “0,” skip
to ste
step
5. Display in
DAILY (MON-FRI
EEKLY
SELECT :a y
END ¿PA
Cc
13 SAT 2:20P 3:20P 02
TODAY
SELECT RECORD SPEED /(%M
SELECT :á ¥
END ¡PROG
SET: 4 >
VCR Plus+ [ PAOG,_ | LIST
IP_DT START STOP_ CH SPD
1.13 2:00P 3:20P 02 SLP
2 =-= amen oir == =-
3 -- --:-- --:-- -- -
v
CANCEL :ADD/DLT
SELECT ¡a ¥ SET:»
EXIT ¿PROG
will not appear.
Press PROG/VCR+
to display PROGRAM.
Press 4»
to select display VCR
Plus+ screen.
Press number keys
to enter PlusCode
number.
To Make Corrections,
press « repeatedly
to delete number, then
repeat step 3.
press PROG/VCR+ to
set.
Press AV
to select ONCE,
DAILY(MON~FRI), or
WEEKLY record
frequency and press »
to set.
Press AV
to change record speed
and press » to set.
Press PROG/VCR+
to end program.
Press PROG/VCR+ again
to exit.
* Press ADD/DLT
to delete the program,
Press POWER off to set timer.
(TIMEP” lights on Multi Function Display.)
`+ PlusCode number is not listed for
POWER
SELECT/
NUMBER
keys
ACTION
ADD/
DELETE
Do normal Timer Record if...
program.
* program (e.g. sports event) may run
over set stop time.
See page 17 to:
* cance! a timer recording in progress.
* review, replace, or clear program
contents.
Important for DSS/Cable Box Users
* When recording via DSS, the receiver
must be left on. When recording via
cable or antenna, DSS receiver must
be off.
+ When recording via a cable box,
leave box on and tuned to channel to
be recorded.
* Do not overlap program times.
¢« VCR PlusCode numbers cannot be
used to program VCR to record DSS
and cable box channels.
« Make each entry within 1 minute or the
VCR will exit setup mode.
* Once VCR Plus+ channel setup is
done, channels stay in memory. If a
power interruption occurs, VCR Plus+
channel setup may be lost. Please do
VCR Plus+ channel setup again.
* Obtain unlisted PlusCode numbers by
calling 1 - 900 - 454 - 7587. Call costs
about $.95 per minute.
JOWILL
a
D
O
O
a i
Q.
3
le

Panasonic Omnivision PV-V4611 Specifications

General

Brand	Panasonic
Model	Omnivision PV-V4611
Category	VCR
Language	English