Panasonic Omnivision PV-V4611 User Manual

Multi-Brand Control Feature
Multi-Brand Control Setup
The Remote Control can be set to control some TV and
Cable box/DSS functions. POWER
1 Find your TV and Cable Box/DSS Receiver Brand
Code Number on following page. TV or
DSS/
CABLE
2 E Setup for TV control,
-->hold down TV button,
-->enter code with number keys.
@ Setup for Cable or DSS control,
-->hold down DSS/CABLE button,
-->enter code with number keys. NUMBER
* If code number is100 or greater, keys
-->press 100 key, then other digits.
E.g., press 100 - 0 - 2 for 102.
Confirm code entry,
3 -->press POWER to turn selected unit on or off. ENTER
* See table below for controllable functions in each mode.
e Repeat setup after remote battery replacement.
e Remote will not control every TV, cable box, or
DSS made by the manufacturer listed. If you get
no response, your particular unit cannot be
controlled. There are NO additional codes for the
products listed. If your product is not listed, then
the remote is not compatible with that product.
Using Multi-Brand Control
After remote is set up, you can select VCR, TV, or DSS/
CABLE for the desired function. -
Press VCR, or TV, or DSS/CABLE on the remote.
(Table below shows available unit buttons for each mode.)
VCR/TV, PLAY,
STOP EJECT,
SAP/ Hi-Fi,
DISPLAY, FF,
REW, PAUSE/
SLOW, REC,
SPEED, CM/ZERO,
RESET COUNTER,
TAPE POSITION
POWER, INPUT,
number keys,
ENTER, CH
UP/ DOWN,
VOL UP/DOWN
VOL UP/ DOWN | POWER, ENTER,
number keys
(except 100key),
CH UP/ DOWN
* Not all functions listed may be controllable.
* In TV or DSS/CABLE mode, it may be necessary to press ENTER
after pressing number keys for channel selection.
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to : consumerproducts@panasonic.com

Panasonic Omnivision PV-V4611 Specifications

General

Brand	Panasonic
Model	Omnivision PV-V4611
Category	VCR
Language	English