Panasonic Omnivision PV-V4611 - Tape Operation (Search System)

Tape Operation
Special VCR Features
Repeat Play
Set to playback a recording over and over.
Press ACTION*
to display menu.
Press AV
to select REPEAT
PLAY and press » to
set ON or OFF.
» Play repeats at tape
end or if unrecorded
portion over 30 sec.
is detected.
2
Press ACTION
to return to normal screen.
To quickly return to a specified tape location.
Press DISPLAY during play
to display Counter.
Press COUNTER
RESET at desired
position
to reset to “0:00:00”.
3 Continue to record, playback, etc.
4 Press Stop.
Press CM/ZERO
in Stop mode
to start ZERO
SEARCH.
+ Unit will go into FF
or REW mode and
stop at the last point
the Counter was set
to 0:00:00.
* If a blank portion exists on the
tape, and depending on the position
of the V mark, the V mark display
position may not be accurate.
For assistance, please call : 1-800-211-PANA(7262) or send e-mail to :
Tape Position Display Feature
To find out the present tape position.
Tape position cannot be detected for VHS-C
Cassette types and tapes of less than 60
minutes length.
Press TAPE POSITION
to detect Tape Position.
* “DETECTING TAPE
| DETECTING TAPE POSITION J POSITION” onl
appears the first time
a cassette is inserted
Y and it takes several
seconds for correct
indication to appear.
* The present tape
x position indication is
eckin — Hn displayed.
een Mao 1
Press TAPE POSITION
to return to normal screen.
Remote Warning ON/OFF Feature
If Multi-brand feature is used (page 20), and this
feature is set to on, a warning appears whenever
an invalid key is pressed in TV, DSS, or Cable
mode.
Press ACTION
to display menu.
[ won, EI AE]
REPEAT PLAY OFF
De SHUT - CFF
Press AY
to select REMOTE
WARNING and press >
to set ON or OFF.
elf “OFF,” remote
warning will not
appear if invalid
key is pressed.
ON
IOMALANGUE : ENGLISH
YCR'S OUTPUT CH :3
SELECT :a Y SET ;»
EXIT__:ACTION
Press ACTION
to return to normal screen.
consumerproducts @ panasonic.com